The "tinted" ceramic medium of the platinum gas heating series transforms the obtrusive red glare emitted by traditional natural gas heating burners into a soft red glow which conveys a feeling of "warmth". This softened glow does not compromise heat output and is a significant aesthetic improvement not seen in any other gas radiant heaters.

• 23600 BTUS
• Heats up to 120 sqft
• Gas connection 3/8" SAE
• Electrical connection 110 Volt, 3-pin insulated plug
• Dimension (WxDxH) 22.05" x 15.59" x 14.85"
• Min. distance to combustible materials
  
• Sides: 3.6’ / 1100mm
• (without heat deflector) Above (to ceiling): 3’6" / 1100mm
• (with heat deflector) Above (to ceiling): 1’2" / 350mm
  
• Mounting height requirement to ground 3 8’ / 2438mm
• Weight (lb) 33lb
  
• Stylish and unique design
• Slim and streamlined
• Brushed stainless steel finish
• Patented design & technology
• Attractive tinted translucent ceramic medium
• Directional ceiling or wall mounts provides greater positioning versatility and heat coverage.

Electronic controls on the platinum gas heating range allow automatic re-ignition if the heater goes out. If the heater does not re-ignite for any reason, the integrated flame failure safety shut-off control turns the heater off immediately.

• Burners protected behind high-temperature translucent ceramic medium
• Flame failure safety shut off
• Gas approved

One or multiple gas heating units can be switched on and off simultaneously from a single remote-located switch.

• Electronic ignition at the touch of a button
• Wind resistant – burners protected behind translucent ceramic medium
• Even and comfortable heat distribution
• Effective utilization of gas
• Heats large areas quickly and efficiently
• Suitable for commercial and domestic outdoor use

• Bromic Patio Heater Brochure

• Must only be installed by a licensed technician. Must complete “Pre-Installation Checklist" before installing
• The temperature will not exceed 65°C/149°F above the ambient temperature at specified distance. Please consult material manufacturer for temperature ratings and suitability. Bromic Heating takes no responsibility for material compliance. 3 8’ / 2438mm or maybe lower depending on local regulations